Pni Legacy Comm Board Manual de usuario descargar pdf (Pagina 21)

PNI Corporation 133 Aviation Blvd., Suite 101, Santa Rosa, CA 95403-1084 USA;, Fax: (707) 566-2261

For the most current specifications, please visit our website at: www.pnicorp.com

Page 21 of 42

ez (Z Axis Data Enable)

Enables the Z-axis data output. The Z sensor output is not available on all modules. Refer to the

specific module data sheet for more information. Z-axis is only active in raw mode.

Syntax:

ez<aq><es>

Response Format: $ez={value}*<dcs><er>

Valid Values: e = enabled

d = disabled (default)

Query Syntax:

ez?<es>

halt (Single Character Halt Enable)

Enables sending a single Halt (h) command to cancel the Continous Output (go) mode.

Syntax: halt

Response Format: $halt={value}*<dcs><er>

Valid Values: e enabled; h (default)

d disabled; h<es>

Query Syntax:

halt?<es>

lpm (Low Power Mode)

Selects the low power mode for the CommBoard. Once set to lpm=2, the CommBoard will

“wake” from ultra low power and go into

lpm=0 when it receives a character over the RS-232

interface.

Table 3 on page 4 lists the current draw at the different lpm levels.

Syntax:

lpm<aq><es>

Response Format: $lpm={value}*<dcs><er>

Valid Values: 0 no conversion (default)

1 LEDs off

2 ultra low power

Query Syntax:

lpm?<es>

CommBoard

Configuration Commands

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 41 42

Sin comentarios

Pni Legacy Comm Board Manual de usuario Pagina 21